Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Sep 20 22:19:06 EDT 2000 | Herman Koo
I am operating MPM AP HiE. The squeegee was just repaced with metal blade, side plastic deflectors(with spring) at both ends. The engineering dept suggested that we level the squeegee with the plastic deflector up. Afterwards, we loosen the screw and
Electronics Forum | Thu Nov 03 01:20:35 EST 2005 | pavel_murtishev
Good morning, Thank you for assistance. I�m not so experienced with MPM maintenance. Explain me please what is the difference between �squeegee down force� and �squeegee pressure�? Squeegee pressure is set so 5-6 Kg. How can I check squeegee down fo
Electronics Forum | Sat Aug 20 15:18:40 EDT 2016 | mahendra
email mskisten@gmail.com for your squeegee Requirements. Thank you, Mahendra.
Electronics Forum | Fri Jul 30 19:27:40 EDT 2010 | dman97
Hi All, Does anyone know how to repair a UP2000 that has the front squeegee lower than the rear? Can this be fixed by playing with the drive belts? The front squeegee is sitting lower than the rear and thus gives an uneven print stroke. The front s
Electronics Forum | Wed Jun 24 00:33:07 EDT 1998 | Phillip Hunter
| | The Ultraprint blade is fine and so is the PERMALEX BLADE. I'm so steamed right now that I actually advertised for Alpha. Now I'm even more upset! They probably even killed Kenny (those Bastards!!) | | | | | So my salesman says to me that we cou
