Electronics Forum | Wed Dec 06 15:59:04 EST 2006 | realchunks
Chris, you need to get out more. I haven't seen a DOS only MPM in many years. Most MPMs do have that new fangled Windows on em'. Shoot, even seen one of them fancy flat screens on one (in the rich parts of the neighborhood)! Seth, what type and y
Electronics Forum | Mon Nov 12 08:04:15 EST 2007 | samir
In my past life, I used a tooling plate by JNJ that is specifically made for MPM's. The theory is - it's an alphanumeric grid, like Battleship, where you figure out your setup once, and then document it. It worked with and fit nicely with the MPM H
Electronics Forum | Thu Nov 08 07:45:03 EST 2007 | hussman
We use the Gel Flex from MPM. Made a different base for each machine. Works well for most boards, but you may need additional pin support for larger boards. No tools, no vaccum hoses, no missprints (which Grid Lock is famous for), and best of all
Electronics Forum | Fri Nov 09 15:52:47 EST 2007 | kmakiya
We have been using Grid Loks on our MPM Accuflex machines and see an offset in the print every so often. Haven't been able to isolate the problem. How bad was the misprint and how was it related to the grid loks? Thanks
Electronics Forum | Mon Dec 08 17:06:54 EST 2008 | smellew
Hi Grid lock & others are ok solutions but i've tried them all the best system i received was from a company in eastern eu called cisoli ltd they supply support systems for DEK's MPM's and any placement machine i used them on DEK ELA Fuji CP642 & IP3
Electronics Forum | Mon Jun 18 08:48:03 EDT 2007 | pavel_murtishev
Good afternoon, Drop some lines to Speed Line technical support (http://www.speedlinetech.com/). I guess they know all their default passwords. BR, Pavel
Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292
I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
winsouce.jpg)
