Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Wed Apr 26 16:18:45 EDT 2023 | cyber_wolf
What model MPM ?
Electronics Forum | Wed Apr 26 18:35:07 EDT 2023 | poly
I'm looking to make a board support table fixture that is connected to the printer and uses the vacuum manifold of the printer. Printer is an mpm Accela
Electronics Forum | Wed Apr 26 19:10:43 EDT 2023 | cyber_wolf
This machines support table looks similar to AP and UP machines. I believe MPM published the dimensions of the "H" tower that the dedicated plates bolts to. As far as the plate, they are typically (2) pieces with the inside hollowed out to allow for
Electronics Forum | Wed Apr 26 06:51:11 EDT 2023 | poly
I'm looking to make dedicated tooling for my mpm stencil printer. We only make 3 different boards and they are the same size panel so I'm planning to make one bit of tooling for them. One board is 0.6 mm and sometimes I have problems with it not bein
Electronics Forum | Fri Mar 19 19:05:27 EST 1999 | Earl Moon
Folks, I think we are getting closer to being very happy with DEK stencil printers of the 265 GSX variety. However, problems continue arising concering fine pitch autoflex tooling pin breakage. We are told by the British engineering establishment,
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Thu Jul 29 11:14:46 EDT 1999 | Justin Medernach
| I'm working on a prototype board that requires a 600 pin BGA. This is a metal top BGA being placed on a 11" x 17" PCB about .62" thick. | | The part is 1.77" square with a 50 mil pitch and 30 mil bump diameter. The bumps are located on the
Electronics Forum | Wed Feb 09 09:54:50 EST 2000 | JAX
Trying to place PTH components with an SMT machine is possible but maybe not plausible. Would you have to buy specialized tools and equipment for the job ( gripper nozzles ). Are the machines you have capable. i.e.. Would you need camera modification
