Electronics Forum | Tue Jan 12 19:07:07 EST 1999 | Earl Moon
| | For process management with SPC of the stencil printing process with a fully automatic stencil printer, what process outpur parameter would you recommend for SPC? | | | | It appears to me that there are two options: | | A: to have a pn chart bas
Electronics Forum | Tue Jan 12 17:56:18 EST 1999 | Jason Hall
| For process management with SPC of the stencil printing process with a fully automatic stencil printer, what process outpur parameter would you recommend for SPC? | | It appears to me that there are two options: | A: to have a pn chart based upon
Electronics Forum | Wed Jan 13 20:44:42 EST 1999 | Steve Gregory
Hello Sanjay! The cheap deal I use that Earl spoke of is called a SMarT Measure. It's a depth measuring microscope that uses the same principle of measuring optical focus that the units from Vision Engineering do ( if you've ever looked at any
Electronics Forum | Thu Jan 14 15:22:14 EST 1999 | Earl Moon
| Steve, | Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my
Electronics Forum | Thu Jan 14 11:08:29 EST 1999 | Mike McMonagle
Steve, Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my seni
Electronics Forum | Sun Sep 25 20:20:22 EDT 2011 | johnyq
We recently aquired an old MPM-AP25 stencil printer that printed paste with a large error (about .060 inches). I concluded camera alignment to be the cause but was surprised by the magnitude. I found the camera beam splitter prism misaligned and loos
Electronics Forum | Fri Jul 15 13:56:18 EDT 2005 | chunks
Here's an easy one. Make a camera that looks up at the board a non-mirror image. You could keep the mirror image toward the stencil since stencils rarely have any legend on em.
Electronics Forum | Fri Aug 17 10:23:37 EDT 2001 | ohanlon
I do not use MPM printers but I find it hard to believe there would be a problem, assuming the MPM printer can be configured for Edge reference stencils. The double image stencil is basically two edge reference stencils in one. Assuming the art work
Electronics Forum | Tue Mar 16 14:37:42 EST 1999 | Steve Gregory
Hi Nancy! Just as Steve and Dean said, most printers have some sort of restrictions of what frame, where the image is positioned, ect. before the stencil will work in the printer. The two manufacturers that I'm most familiar with DEK and MPM do have
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
| 1 |
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
winsouce.jpg)