Electronics Forum | Tue Jul 23 07:55:24 EDT 2019 | ashray
how can I change the language in MPM up 2000? the machine has a default language set to german I wanted to know if it can be changed to English. I tried in BIOS there is no option to do that. Please guide me on this.
Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Tue Aug 15 12:02:55 EDT 2006 | pr
Check your gel flex. They're no good. Don't use em. good Luck pr
Electronics Forum | Tue Aug 15 09:40:43 EDT 2006 | SWAG
Not sure about 2020 but AP's have an option to perform a histogram test/adjustment on the lighting. It's a black card, white card test and you can adjust a pot. in the machine to make the histogram curve "best-fit". On an AP, you find this option i
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Fri Mar 17 09:03:52 EDT 2017 | daleb
Hello New to forum, I have a mpm ultra print 1500 can not find a lube coupler for the Z axis slide bearings. Does anyone know what it is and where could I find one. A standard grease coupling does not fit. Thanks Dale
Electronics Forum | Mon Mar 20 13:49:21 EDT 2017 | pjc
That's a U.K. machine, so the zerk fitting is not standard to USA. You can replace it with a standard, like from Grainger: https://www. Grainger.com/category/grease-fittings/ecatalog/N-14rvZ1z0do6q MPM can't help as that machine is obsolete, but PPM
Electronics Forum | Tue Mar 28 19:56:47 EDT 2017 | aemery
Dale, Be very careful about putting to much grease into this actuator. It is kind of a sealed unit. If you were to take this actuator apart you would see that the motor drives a heavy pitched threaded screw. As it turns it causes the threaded tube
Electronics Forum | Wed Apr 18 00:49:13 EDT 2018 | mohsenpour
hello my printer is mpm up2000 software on windows nt4 not working i want soft(apnt.exe) or image for this machine
