Electronics Forum | Fri Mar 17 09:03:52 EDT 2017 | daleb
Hello New to forum, I have a mpm ultra print 1500 can not find a lube coupler for the Z axis slide bearings. Does anyone know what it is and where could I find one. A standard grease coupling does not fit. Thanks Dale
Electronics Forum | Mon Mar 20 13:49:21 EDT 2017 | pjc
That's a U.K. machine, so the zerk fitting is not standard to USA. You can replace it with a standard, like from Grainger: https://www. Grainger.com/category/grease-fittings/ecatalog/N-14rvZ1z0do6q MPM can't help as that machine is obsolete, but PPM
Electronics Forum | Tue Mar 28 19:56:47 EDT 2017 | aemery
Dale, Be very careful about putting to much grease into this actuator. It is kind of a sealed unit. If you were to take this actuator apart you would see that the motor drives a heavy pitched threaded screw. As it turns it causes the threaded tube
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Wed Jun 23 22:18:51 EDT 2004 | PCA
Does any one have a copy of the error diagnostic code listing for this machine?
Electronics Forum | Thu Jun 24 13:24:18 EDT 2004 | pjc
Contact Sigmaprint for the error code list. www.sigmaprint.co.uk
Electronics Forum | Mon Jul 31 16:33:48 EDT 2006 | G.P.
I think he meant stencils where the print pattern is front, left, or right justified on the stencil itself as opposed to being centerred. Is that what you meant. It can be done on DEK printers, but it has been several years that I worked with an MP
Electronics Forum | Thu Dec 29 18:44:36 EST 2022 | compit
Yes, there are two lengths. My MPM UltraPrint 2000 HiE has trays protruding from the machine about 15 cm, I think. I'll check with the company tomorrow to see if there are any numbers in the manual. I have a link to the part saved - maybe check it ou
Electronics Forum | Tue Nov 26 09:19:29 EST 2002 | pjc
MPM UltraPrint 2000 2D Inspection Times: QFP 256 pin 16Mil pitch is 7.5 seconds BGA 225 ball 20Mil pitch is 1.8 seconds Find out the DEK times for these devices. Any UP2000 of 1995 mfg. date oand on can be upgraded to the latest software. Concer
