Electronics Forum | Sat Apr 09 23:14:36 EDT 2005 | MikeaJ
In response to the post concerning the UP1500, the case is a little different. The Speedline/SMTech passwords are hardcoded into the Sigpro.exe file. Here is what you need to know: Login name: Speedline (or SMTech) Passwords are listed in order of ri
Electronics Forum | Wed Jul 21 18:05:44 EDT 2010 | empac
Hello, Does anyone have the following MPM UP3000 Spare part Part number 1001333 Description: MOTOR,M40 Z-AXIS, MODIFIED Thanks. Bob
Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin
I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.
Electronics Forum | Mon Aug 14 11:30:25 EDT 2006 | SWAG
We had centernest to I/O track alignment problems that were not predictable on 3000. Z-axis height seemed good with relation to I/O tracks but y was misaligned. Ended up replacing y-axis stepper and trouble went away. Also have had trouble with z-
Electronics Forum | Fri Dec 05 12:16:35 EST 2003 | pjc
The UP3000 & UP3050 are the same machine. The "3050" denotes an options set. The current model is an UltraFlex 3000, which replaced the UltraPrint 3000 series.
Electronics Forum | Sat May 30 07:06:42 EDT 2015 | et1972
Hi I have a MPM3000HI printing machine with a following problem : Unable to run at high speed for z axis ,machine will stop at certain points . Have change ballscrew,nut ballscrew,motor and brake but still the same. Now run at low speed at 1 but t
Electronics Forum | Thu May 24 12:56:31 EDT 2007 | adlsmt
Im sure you will get some better responses but here is a start. We went from UP2000 to UP3000 Ultraflex about 2 years ago. The UP-2000 uses tooling nests and UP-3000 Ultraflex does not. Makes a huge difference in setup time. Up-3000 is BIG. I think t
Electronics Forum | Mon Jun 01 09:29:22 EDT 2015 | tnisbet
Did you change the Z-Axis amplifier? Do you have the old black unit or the new retro(blue box)? Have you checked the rear distribution board for a bad or burnt connection? If you haver any further questions please contact george@goppm.com
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less