Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an
Electronics Forum | Thu Jun 22 12:25:02 EDT 2006 | vikkaraja
and type the following: optedt and press enter.Password for this is QMPM. Good luck and keep us posted.
Electronics Forum | Sun Jun 25 23:42:57 EDT 2006 | dman97
OK guys, thanks for your help. I got everything setup back to the way it was. You guys were very helpful.
Electronics Forum | Sun Feb 13 20:12:53 EST 2000 | K. S. PARK
Hello . i am reviewing the s/p dek (dek 265 infinite) ,mpm (up3000). all user say the machines are good. but to me rheopump versus proflow. which one is better. someone out there using these head advise me. bad or good thing whatever it is
Electronics Forum | Tue Mar 07 00:03:24 EST 2006 | rbodmer
i no longer work with mpm machine's but mpm has excelent tech service and there manuals have all error codes listed. www.speedlinetechnologies.com
Electronics Forum | Thu Jul 25 09:56:39 EDT 2019 | ashray
how can I change the language in MPM up 2000? the machine has a default language set to german I wanted to know if it can be changed to English. I tried in BIOS there is no option to do that. Please guide me on this.
Electronics Forum | Mon Feb 27 13:33:03 EST 2006 | Robert
Our MPM 2000 screen printer machine has a problem. During the machine reset mode a warning message come up "Z lockout not operating". Does anyone know what fault could cause this?
Electronics Forum | Tue Mar 07 00:11:30 EST 2006 | jgarver1
Is this a new machine to your facility? I have seen MPM UP3000's give error while homing if the transformers are not tapped exactly at the line voltage. Just a thought.