Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Wed Apr 03 03:19:37 EDT 2024 | ddfreeze
boots with cmos battery low message. I do not see a battery anywhere to replace. F1 utility does not seem to work. hard drive is good. do not have an A: boot disk
Electronics Forum | Fri Apr 05 01:25:14 EDT 2024 | ddfreeze
My research taught me that most older 486 motherboards have a similar CMOS substitution chip that you can purchase, or modify the one you have with a battery as shown.
Electronics Forum | Fri Apr 05 01:34:09 EDT 2024 | ddfreeze
the F1 bios menu thing did not work no matter what options I chose. The fix is to do the mod to the CMOS chip, or gamble on a substitute replacement.
Electronics Forum | Fri Apr 05 04:41:41 EDT 2024 | hta1979
I'm glad it was successful. According to them, the cmos setting was preserved. If the battery is completely discharged, it must be restored to the original state. The setup menu should work, but then there was no need for it.
Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
