Electronics Forum | Wed Nov 26 10:10:13 EST 2014 | swag
Reseat all the connectors on the cards make sure pins are clean and no corrosion. Not sure what to say about current, etc. There is or was a place on the east coast that repairs these cards. Can't remember who it is - sorry not much help with that
Electronics Forum | Fri Jun 10 15:56:04 EDT 2016 | comatose
A UP2000 is a great choice. I'd avoid the AP family from MPM. It's not that they're bad, per se, but the air bearings make it fiddly, maintenance intensive and a giant air hog, and you don't need the speed.
Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas
board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?
Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas
that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.
Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t
Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..
Electronics Forum | Thu May 09 01:43:56 EDT 2019 | compit
in my camera did not detect PCBs from light green laminate - did you try on a different color PCB?
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Fri Dec 13 08:55:06 EST 2019 | richardcargill
We've got an MPM Speedline AP/B that's in Imperial ( inch ) units - everything else here is Metric. Can this printer be configured to Metric units ? Software AP/UP2000 sw ver 7.0c currently installed if that makes any difference Cheers
Electronics Forum | Fri Jul 03 12:59:00 EDT 2020 | compit
I enclose a piece of instruction - here I think the offset is set. Pages are not in turn, but you can handle it?
Electronics Forum | Sat Jul 04 04:00:09 EDT 2020 | zsoden
Thank you Michal but unfortunately the images have not come through. I have sent you an email that perhaps you can send them to?