Electronics Forum | Wed Apr 13 04:09:15 EDT 2005 | simmcircuits
Hi, I need help with our MPM UP2000, the stencil and the lamp boards won't turn off completely, they are both on at the same time. Turning it on would only make it brighter, turning it off will just lose the brightness but the lamps are still on. I h
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Sat Jul 16 18:40:12 EDT 2016 | aemery
As an MPM guy and would choose.....MPM, surprise! Of the legacy models the UP2000 seems to be the favor among most of my clients. Newer models like the Accuflex's and Accela/Momentims are great, but as far as the old stuff the UP2K's are the favorit
Electronics Forum | Wed Jul 01 05:33:29 EDT 2020 | zsoden
I recently purchased a used MPM UP2000 printer that I'm getting up and running. It's in very good condition and other than a worn out auxiliary on the main power contactor seems to be all working correctly. I've got it operating in demo/dry run mode
Electronics Forum | Sat Oct 28 13:28:17 EDT 2000 | Ramon I Garcia C
Hi guys: I have IPII and MPM UP2000 not programable head, I need process BGA, but I never had been process it, I want to know "if I can run it, if not, what I need to do" Please give me some tips, and excuse my english. Ramon.
Electronics Forum | Mon Aug 07 16:23:34 EDT 2000 | Ramon I Garcia C
Hi!!! Thanks frieds for your advising, I have a MPM UP2000, I'm going to chek the humidity control, too I'll chek the profiles again, this plant it's located close to the beach about 1/2 mile from. However if you know some table to calculate t
Electronics Forum | Sat Jul 10 18:19:16 EDT 2004 | Alfredo Diaz
Hello All, We are in the process of setting up a SMT line and would like you guys to recommend a company who help us to do the movement, set up and alignment of the machines. Machines are MPM UP2000, Fuji CP642, Fuji IPIII, Heller 1800EXL Oven. Tha
Electronics Forum | Thu Aug 26 22:10:43 EDT 2004 | KEN
I work for a CM that is a principle PCBA supplier for Cognex. We have not seen these legacy systems in many, many years. However, the cognex 8000, IS1000, IS2000 systems are still running strong in many OEM vision applications (especially recently
Electronics Forum | Fri Jul 15 02:26:47 EDT 2005 | fastek
OK...here's another one. The HiE designation began with UP-2000's I believe. And if I'm not mistaken the difference between a HiE and a non HiE was speed improvements as it related to axis movement times. If you could figure out a way to accomplish t
Electronics Forum | Fri Mar 31 13:18:39 EST 2006 | Chunks
Almost 4-got. Get some squeegee blade detents. They're the little spring loaded things that keep the squeegee blades in place in the head, until the machine locks them in place. they tend to wear out if you do a lot of blade swapping. Fastek also