Electronics Forum | Wed Sep 30 06:31:07 EDT 2015 | mervin
Thanks SWAG, I have checked the FP mode, I am aware of this. I have also worked on this machine some over 10 years ago but not as a service engineer. So I aware of the programming on the machine its just trouble shooting this particular machine is n
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Thu Sep 15 06:45:26 EDT 2016 | awhite
Hi Ariss_T, Thanks! I actually did check that...that was one of my first thoughts as well. While in the I/O, I slide a raw board back and forth under the camera/sensor and it acted appropriately. I will definitely update this thread as new informa
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Tue Nov 26 09:19:29 EST 2002 | pjc
MPM UltraPrint 2000 2D Inspection Times: QFP 256 pin 16Mil pitch is 7.5 seconds BGA 225 ball 20Mil pitch is 1.8 seconds Find out the DEK times for these devices. Any UP2000 of 1995 mfg. date oand on can be upgraded to the latest software. Concer
Electronics Forum | Sat Oct 04 21:43:32 EDT 2003 | lysik
I have 12 of the 500 series machines. For runner to the 1500. I had some software bugs but upgraded to the latest software. In 12 months of 3 shift a day production (with 1 day for maint) I have only spent about $500 USD in repair parts. I do also ru
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Thu Dec 08 22:35:41 EST 2005 | fastek
Harry- That's true but we weren't hear to discuss what's the cheapest printer around. The guy wants to step up in technology without jumping into the Mercedes-Benz of printing. In my mind any MPM printer below a UP-2000 would not serve his purpose.
Electronics Forum | Fri Sep 01 18:59:40 EDT 2006 | chrisgriffin
Fastek- From the sound of the attitude, you must be competition. And trust me, we do much more than clean them up and paint. How about you? But thanks for the sarcasm. And when you've refurbished a hundred MPM's, you tend to become an expert.
Electronics Forum | Tue Mar 06 08:33:40 EST 2007 | cardinal
You can get a topside edge-clamping system to fit your AP HI E printer from Gridlok. They make a universal tooling system and topside edgeclamping system for the AP series and UP 2000 series printers. The Y snugger tooling option when ordered with t
