Electronics Forum | Tue Jul 30 22:11:09 EDT 2024 | zsoden
We've been running a trusty MPM UP2000 printer for a few years now but the 30 year old technology is starting to struggle a bit. It didn't come with snuggers and the vacuum hold down just doesn't cut it for some of the finer pitch stuff we're now doi
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes
Electronics Forum | Thu May 24 12:55:19 EDT 2007 | pjc
First off, go with HiE (Hi Efficiency) machines only. UP3K and UP2K have huge differences- board size, speed, options, etc... too many to list really. I would recommend UP2K HiE over UP3K HiE. Its a simpler machine and easier to find on the used m
Electronics Forum | Mon May 12 11:36:35 EDT 2008 | cyber_wolf
Harry,I know what you mean. You are completely right and justified. My father owns his own business and I see stuff like what you described all of the time. Yes we have done business before. I worked with you when you were with MPM and after you st
Electronics Forum | Fri Aug 06 12:36:37 EDT 2010 | ooskii
dman97, There is a calibration procedure. It is fairly straight forward and will take about 30 minutes. When you reset you machine both of the squeegee mounting blocks/fixtures should be level with each other. Just slide you finger over the fron
Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Fri Nov 08 09:24:16 EST 2002 | rspoerri
Hi, I'm setting up an new production line for cell phone manufacturing and am looking for a second printer for the back half of the line. I am looking at both new and used though used is looking pretty attractive due to the glut of equipment curren
Electronics Forum | Thu Dec 08 16:08:25 EST 2005 | fastek
If you are happy with DEK I would stick with that. I'd look at an ELA or a Horizon model 03...which is their stripped down Horizon version. You can buy a new one of those in the $60K range...used obviously less. The only other vendor I would look a
Electronics Forum | Fri Mar 31 11:46:57 EST 2006 | fastek
Larry- I notice most of your posts either start out or end up like ......."I don't know anything about this, but there was a guy that worked here and he told me"...... WTF? You're not bringing anything to the table when you make judgements/opinion