Electronics Forum | Sun Jun 25 23:42:57 EDT 2006 | dman97
OK guys, thanks for your help. I got everything setup back to the way it was. You guys were very helpful.
Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Wed Apr 03 03:19:37 EDT 2024 | ddfreeze
boots with cmos battery low message. I do not see a battery anywhere to replace. F1 utility does not seem to work. hard drive is good. do not have an A: boot disk
Electronics Forum | Fri Apr 05 01:25:14 EDT 2024 | ddfreeze
My research taught me that most older 486 motherboards have a similar CMOS substitution chip that you can purchase, or modify the one you have with a battery as shown.
Electronics Forum | Fri Apr 05 01:34:09 EDT 2024 | ddfreeze
the F1 bios menu thing did not work no matter what options I chose. The fix is to do the mod to the CMOS chip, or gamble on a substitute replacement.