Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Fri May 03 14:52:32 EDT 2019 | rusar
Hi, we bought the old UP2000 (2005 year) and are trying to teach him a new board. But at step 4 (Board stop X-axis) we get an error "Board stop sensor not made". Can anyone help and say what is the cause of the error? BR, Ruslan.
Electronics Forum | Thu May 09 10:37:35 EDT 2019 | slthomas
Disclaimer - I know nothing specific about MPM printers. First, a question - have you successfully printed or programmed a print cycle for any other board yet, or is this the first one? I ask because a board stop sensor error sounds like it could b
Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t
Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..
.gif)
winsouce.jpg)
