Electronics Forum | Thu Jun 22 12:25:02 EDT 2006 | vikkaraja
and type the following: optedt and press enter.Password for this is QMPM. Good luck and keep us posted.
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Sat Apr 09 21:44:07 EDT 2005 | Marcel
Go in dos, go in the CONFIG dir. Edit the file ACCES.000 Yours passwords are there. You can delete the file and reboot, that will reset all passwords to factory default Operator MPM1 Maintenance MPM2 Supervisor MPM3 Calibrate MPM4 M
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Wed May 29 08:47:30 EDT 2013 | zrunkle_api
I'm trying to get into the Calibration section of the machine and don't know the password. I'm would believe it's still the Default password since the maintenance mode is still the Default password "SVC".
Electronics Forum | Mon Aug 02 08:58:43 EDT 2010 | kpm135
It's been a while but I believe the UP2000's should have a calibration for the squeegee height as well. I think you log in under the Calibrate or Maintenance then that should give you access to the menu you need. Once you find it I'm pretty sure it w
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Thu Aug 13 19:51:47 EDT 2009 | prasadz
Jagadeesh Rajagopalan is the expert in MPM Screen printer Servicing and he suggest to do the calibration of Z axis with PCB thickness (1.3mm)
