Electronics Forum | Wed Apr 18 00:49:13 EDT 2018 | mohsenpour
hello my printer is mpm up2000 software on windows nt4 not working i want soft(apnt.exe) or image for this machine
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Thu Jun 22 12:25:02 EDT 2006 | vikkaraja
and type the following: optedt and press enter.Password for this is QMPM. Good luck and keep us posted.
Electronics Forum | Sun Jun 25 23:42:57 EDT 2006 | dman97
OK guys, thanks for your help. I got everything setup back to the way it was. You guys were very helpful.
Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
.gif)
winsouce.jpg)