Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the
Electronics Forum | Mon Apr 28 21:51:56 EDT 2014 | elabcircuits
Hello, We have a MPM UP2000 HiE printer from 2000, software version 7.2E. The PC board is not booting anymore (black screen), no drives spinning. It's an Advantech 486SX version. Question: would a Pentium 3 SBC (Single Board Computer) with ISA
Electronics Forum | Tue Sep 22 08:03:49 EDT 2015 | mervin
Hi. I have recently purchased a old MPM UP2000. I can not get it print correctly consistently. It goes off after 5 Pcb's and remain that amount off for another 5 Pcb's. Then it goes more off and remain like that for another 5 Pcb's. If you stop and e
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Tue Jan 23 13:15:44 EST 2007 | stepheniii
Shouldn't the top of the board be at the exact same height as the top of the side clamps? Why are the clamps holding the stencil up off the board?
Electronics Forum | Wed Aug 30 23:58:53 EDT 2006 | jasmin
We are looking into purchasing a used UP-2000 > Hi-e. We are high mix /high change-over. The > machines I am looking at are equipped with the > grid-lok system. > > Can anyone give me pros's/ > con's ?? > > Thanks in advance. > > Sr. Hi Sr T
Electronics Forum | Thu Sep 07 09:04:24 EDT 2006 | Doug Eidle
Hi, First off, I am the Pre Owned Equip. Business Mgr. for Speedline Technologies. We have a factory Renewed (our enhanced refurbishment process) available. You can contact your local Speedline MPM Rep for price and information. If board warp is
Electronics Forum | Mon Jul 29 08:28:05 EDT 2002 | pjc
Start killing DEK now, on the ELA. All DEK 248 semi-auto printers have been built in China for quite some time (years). Its shipped to the UK from China. All DEK ELA models are now built in China, since 01 some time. Thats the fact Jack. All MPM mod