Electronics Forum | Thu Dec 01 16:11:03 EST 2011 | cowens
I have a MPM UP2000. When running or after teaching fiducials you will here a clank and the error "Camera not parked" will show. If anyone has experienced this on have any suggestions plaese advise. Thank you.
Electronics Forum | Tue Nov 30 20:44:09 EST 2004 | bbyrd36
Good Evening - I am looking to purchase a video card for my UP 2000. The current configuration has a two board design and I am in need of the board mounted on the right looking from the back. Please contact me if you have one with availablity and p
Electronics Forum | Fri Jul 30 19:27:40 EDT 2010 | dman97
Hi All, Does anyone know how to repair a UP2000 that has the front squeegee lower than the rear? Can this be fixed by playing with the drive belts? The front squeegee is sitting lower than the rear and thus gives an uneven print stroke. The front s
Electronics Forum | Sat Jun 01 10:35:16 EDT 2013 | aemery
No! Equipment OEM's have to license each CPU box or OS they sell. Your system machine software 8.4.3? is built to run on an NT OS. Microsoft no longer supported NT when the UP2000's/AP printers were converted to NT from DOS around 1999-2000. Speedl
Electronics Forum | Fri May 03 14:52:32 EDT 2019 | rusar
Hi, we bought the old UP2000 (2005 year) and are trying to teach him a new board. But at step 4 (Board stop X-axis) we get an error "Board stop sensor not made". Can anyone help and say what is the cause of the error? BR, Ruslan.
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Thu Jul 25 19:18:42 EDT 2002 | lysik
I really would not compare the 2 systems. A ELA is more like MPM's UP-1500. The UP-2000 is more like the DEK Horizon or Infinity. You just opened up one of the great debates of the SMT world. MPM or DEK? You will have people on both sides defend the
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
Electronics Forum | Wed May 15 15:55:52 EDT 2002 | swagner
The Dek Infinity will cost you anywhere from $170-$210k dependant on option, I.E. gold camera, form flex support tooling, proflow printhead, paste inspection and aperature inspection all drive the cost of this machine. The only MPM I have quoted lat
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
.gif)
