Electronics Forum | Wed Dec 06 23:54:24 EST 2006 | valuems
Think you will find every mpm is operating on dos base software, just in the last 2 years have they got software with windows base. The mouse is related to the version of software, and the old software requires only one model of mouse. Give up tryi
Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Tue Apr 10 05:58:41 EDT 2018 | smr
Dear All, my MPM UP2000 currently running with software vision 8.4.3 and OS Windows NT4. Possible or not to load/select the product program by using scanner ? Pls advise . . . . . Thanks
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Fri Mar 31 13:18:39 EST 2006 | Chunks
Almost 4-got. Get some squeegee blade detents. They're the little spring loaded things that keep the squeegee blades in place in the head, until the machine locks them in place. they tend to wear out if you do a lot of blade swapping. Fastek also
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
