Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Thu Aug 06 11:41:10 EDT 2009 | swag
Is the aperture pattern on your stencil centered in the Y?
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Thu Aug 06 13:54:13 EDT 2009 | lockj69w
We have this problem typically after a PM is performed and it is usually due to too much grease on the linear guide.
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes
| 1 |
