Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Aug 02 11:16:02 EDT 2010 | dman97
Thanks for the answers guys. I knew it had something to do with the calibration menus. It had just been so long since I had to do maintenance to an MPM printer. I had been working with DEKs and Ekras for the past 6 years.
Electronics Forum | Fri Mar 31 13:18:39 EST 2006 | Chunks
Almost 4-got. Get some squeegee blade detents. They're the little spring loaded things that keep the squeegee blades in place in the head, until the machine locks them in place. they tend to wear out if you do a lot of blade swapping. Fastek also
Electronics Forum | Mon Oct 31 03:42:47 EST 2005 | pavel_murtishev
Good day, Problem appears only with 0.5mm pitch components. Print quality for these components is unacceptable. Paste type isn�t new for us. No any tape on the bottom of the stencil. We apply enough pressure on squeegees, stencil remains clear after
Electronics Forum | Fri Aug 06 12:36:37 EDT 2010 | ooskii
dman97, There is a calibration procedure. It is fairly straight forward and will take about 30 minutes. When you reset you machine both of the squeegee mounting blocks/fixtures should be level with each other. Just slide you finger over the fron
Electronics Forum | Mon Aug 02 08:52:57 EDT 2010 | vetteboy86
I can't say that I have an answer as to fixing the mechanics of your issue. However, doesn't that machine have an auto blade height? If so, even with one blade lower than the other, the blade height should only depend on stencil height. I could be co
Electronics Forum | Thu Aug 12 22:38:44 EDT 1999 | Dave F
| Hello | | Having a problem with bridging on 20mil pitch qfp, only on the lead groups where squeegee goes over width of apertures. Using MPM sp-200 semi-auto, chem-etch stencil, 9-10mil width opening | 100 durometer blade. Getting "tails" on deposi
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue Sep 05 16:26:53 EDT 2006 | Bill
Thinking about this auto-mode on Grid-Lok..... Ok, the board is warped, lets say positively, the pins conform to the warped board... what about the effect on top side and squeegee pressure? It will be much higher and could damage stencils, right? Pos
Electronics Forum | Tue Jun 01 18:06:36 EDT 2004 | Rob
I used an Ultraprint 2000 so if that's what you use then maybe I might be able to help. First, I'm assuming that you've already passed the Teach New Board section. This is board dimension, X and Y boardstop, stencil/squeegee heights and strokes. If
