Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Tue Apr 10 05:58:41 EDT 2018 | smr
Dear All, my MPM UP2000 currently running with software vision 8.4.3 and OS Windows NT4. Possible or not to load/select the product program by using scanner ? Pls advise . . . . . Thanks
Electronics Forum | Tue Aug 11 16:25:06 EDT 2009 | quaker332007
You should try recalibrating the vision. That should fix the problem
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Fri Jul 03 12:59:00 EDT 2020 | compit
I enclose a piece of instruction - here I think the offset is set. Pages are not in turn, but you can handle it?
Electronics Forum | Sat Jul 04 04:00:09 EDT 2020 | zsoden
Thank you Michal but unfortunately the images have not come through. I have sent you an email that perhaps you can send them to?
Electronics Forum | Sun Jul 05 08:10:30 EDT 2020 | compit
I didn't get anything - send it to zaopatrzenie@compit.pl, I'll send it tomorrow.
Electronics Forum | Wed Jul 01 05:33:29 EDT 2020 | zsoden
I recently purchased a used MPM UP2000 printer that I'm getting up and running. It's in very good condition and other than a worn out auxiliary on the main power contactor seems to be all working correctly. I've got it operating in demo/dry run mode
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723