Electronics Forum | Tue Sep 29 10:10:34 EDT 2015 | swag
We used to have a UP3000. Long time ago so I'm rusty but isn't there a setting for fid correction that you an program to occur after each board or after 5, 10, etc.? I thought I remembered doing offsets on ours as the camera was a little wacky (old
Electronics Forum | Mon Nov 25 20:57:23 EST 2002 | Kermit
Thanks to everyone who has responded so far. We are going with dedicated tooling for our phone cards but not for our system cards so that takes that out of the equation for the former, will evaluate for the system bds.. Thanks for the info.. Regard
Electronics Forum | Wed Oct 28 13:29:11 EDT 2009 | swag
Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.
Electronics Forum | Wed Feb 23 15:24:24 EST 2000 | Michael Uganecz
Steve, Give MPM/Speedline a call and see if they still sell the SPM-AV, it's a shuttle style printer with vision alignment. It has a really nice auto-align vision system that will move the table in x,y and theta. It's not a look up/look down syste
Electronics Forum | Wed Feb 23 15:24:24 EST 2000 | Michael Uganecz
Steve, Give MPM/Speedline a call and see if they still sell the SPM-AV, it's a shuttle style printer with vision alignment. It has a really nice auto-align vision system that will move the table in x,y and theta. It's not a look up/look down syste
Electronics Forum | Fri Sep 22 13:03:26 EDT 2006 | daxman
I ran the vision test...here is what I got. Camera System: Completed Repeatability VX mean = -3.177942 Standard Deviation = .000059 VY mean = -12.114077 Standard Deviation = .000065 Vision System: Completed Repeatabi
Electronics Forum | Thu Nov 10 11:48:03 EST 2016 | awhite
I recently had a similar problem on our 2000Hie, although ours was a 7-Hardware, Vision X. Turns out there was a short/break in the 3-wire harness that controls the Vision X Stepper. The difficulty came from the fact that this particular harness is
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
Electronics Forum | Tue Jun 01 16:42:48 EDT 1999 | Scott S. Snider
| After lots of years with Panasert machines, I am starting to need to learn again. | 1. For the AP-20 can you retrofit 3D vision? Would you bother? | 2. Also for the AP, can you use 20x20 DEK screens with an adapter? | | Thanks to all you MPM expe
Electronics Forum | Thu Aug 13 19:54:01 EDT 2015 | aemery
The camera assembly is designated as X23; the stencil & board lighting as well as the camera video signal pass through the DB9 connector at the camera. There is a ribbon cable in the vision gantry tray that carries both to the box on the left side o
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723