Electronics Forum | Wed Mar 21 17:47:05 EDT 2007 | darby
You need to use the H nozzle and 4 small jaws (1005). Have the slot in the jaws machined towards the rear of the jaw to increase reach. Set up and calibrate that head with that chucking assembly. Always use the same chucking assembly on the same he
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Tue Feb 28 12:34:12 EST 2006 | pr
Gel flex is crap! If you put enough in to actually support the board, it bows. Apparently MPM knows this because they include hard pins with the set (kinda defeats the purpose huh)! I trialed the grid-lok and it worked fine and operators loved it. Th
Electronics Forum | Fri Sep 17 23:59:40 EDT 1999 | JAX
| | | HI everyone, | | | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00
Electronics Forum | Mon May 12 10:22:40 EDT 2008 | vms
Hi Sr. Tech well I'll tell you why. If the people that bought these so called bargains, would as least call and ask for the price for a machine. But no they buy a piece of equipment and then expect to get free tech support to get it to work. Then
Electronics Forum | Mon May 07 15:03:06 EDT 2007 | jmelson
Yes, I took the chuck off head 3, and made my own nozzle, which is working quite well. I can't set head 3 to vision, as this machine doesn't have the vision system. I set it to "IC" and that seems to work fine. I set mech alignment 1 and 2 to yes,
Electronics Forum | Tue Aug 29 10:36:09 EDT 2006 | Chunks
With the UP2000 that has vacuum board hold down, the Grid Loc hoses defeat the vacuum in order for them to exit the work table. Big boards require more girds, thus more hoses. Set-up between large and small boards takes time to remove or add the gr
Electronics Forum | Thu Nov 17 17:44:19 EST 2011 | bobpan
Tim, 1. You dont need the vacuum verify if the quadalign is working properly. If you have the part quad-aligned and dont have alignment type at 0 it will never 'not' place a part. More or less...the vac verify was needed for the chucking machine (3c)
Electronics Forum | Thu Nov 11 08:06:00 EST 2004 | no gel pig fan
I would definately try to sell the bosses on the Grid-lok over the gel piggies. We evaluated both and wound up buying the Gel (for close to the same money). On an MPM if you put enough gel packs in the vacuum box (to support the board) it holds the b
Electronics Forum | Wed Sep 30 05:10:28 EDT 2015 | aemery
SWAG does make a good point. The tool he is talking about is located on setup page 1 in the vision box and is labeled FP Mode (Fine Pitch) mode. BY default the setting is "0" this means that once the machine is put into auto mode the camera or visio
