Electronics Forum | Sun Nov 22 17:52:49 EST 2015 | wesleyintelli
Hi Deni, Thanks for your interest in my problem. It turned out that the power supply to the VGA vision board (the system in the black box)was faulty. I replaced it with a universal PC power supply and all is well.
Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Thu Mar 04 22:38:54 EST 2021 | tomek_k
Hi Miałem taki problem, myślałem też że to uszkodzona karta Cognex. Zakupiłem nową i to nie pomogło. Okazało się że trzeba zainstalować właściwy sterownik karty. (translate from PL) regards Tomek
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Mon Jun 08 16:49:15 EDT 2009 | joshuas
has anyone experienced a x-axis vision error on MPM ultraprint HiE 3000? The only solution for me so far, is to save the program as another name and reload the original. This corrects the problem although only a temporary fix. is there a permanent
Electronics Forum | Wed Aug 20 20:33:12 EDT 2008 | proy
You should get yourself into DOS, and try to detemine if the mouse driver is loading properly. What .exe program do you have? I have an early touch screen unit which had SPM.EXE and functioned with a touch screen and no mouse. I have converted it
Electronics Forum | Tue Aug 11 16:25:06 EDT 2009 | quaker332007
You should try recalibrating the vision. That should fix the problem
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Mon May 13 13:45:33 EDT 2019 | whitelancer64
I am having the same problem with the MPM Accela solder paste printer machine. If the fiducials are adjusted for PCB alignment, the location of the paste is then wrong, and vision inspection fails. This is a problem for both pad preview inspection
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
winsouce.jpg)