Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Thu Aug 06 13:54:13 EDT 2009 | lockj69w
We have this problem typically after a PM is performed and it is usually due to too much grease on the linear guide.
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Wed Mar 25 11:16:35 EDT 2020 | richardcargill
Currently working through a myriad of air leaks on an old MPM Ap -b and have a question that hopefully one of you fine people may know the answer to. The camera vx and vy use linear rail motors. As far as I can tell, there are nozzles between the sur
Electronics Forum | Tue Feb 21 08:12:11 EST 2012 | vparis
Hey I am in need of the following replaclment parts for an MPM SPM-AV s/n: 7095 Im looking for the Z-Axis Motor MPM p/n: 000298 and a Z axis belt MPM p/n: p2387 Let me know if you have any of these or you can shoot me in the right direction.
Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin
I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.
Electronics Forum | Mon Aug 14 11:30:25 EDT 2006 | SWAG
We had centernest to I/O track alignment problems that were not predictable on 3000. Z-axis height seemed good with relation to I/O tracks but y was misaligned. Ended up replacing y-axis stepper and trouble went away. Also have had trouble with z-
Electronics Forum | Wed Apr 08 18:47:57 EDT 2009 | swag
Could be the z-axis driver card???
Electronics Forum | Mon Jun 08 15:11:38 EDT 2009 | joshuas
.
Electronics Forum | Tue Jun 16 08:18:42 EDT 2009 | kircchoffs
check your bulb on the fiducial camera. It may be busted.