Electronics Forum | Thu Sep 24 07:18:27 EDT 2015 | anilwagh
Check all axis driver card,input supply connector may burn.
Electronics Forum | Mon Jun 08 16:49:15 EDT 2009 | joshuas
has anyone experienced a x-axis vision error on MPM ultraprint HiE 3000? The only solution for me so far, is to save the program as another name and reload the original. This corrects the problem although only a temporary fix. is there a permanent
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Thu Mar 17 12:45:54 EST 2005 | Micheal
I am looking for the Procedure to Calibrate the Z-axis gears (blades) on a MPM SPM Screen Printer. Does anyone have it, I would appreciate it.
Electronics Forum | Mon Feb 27 21:08:21 EST 2006 | ChrisG
I have never seen that message before, but you should check the Z axis driver card, and the Z home sensor. Do you hear anything when the axis tries to move?
Electronics Forum | Mon Jun 19 21:25:47 EDT 2006 | Chris
Try raising the table in Calibrate mode. Sensor or Tactile connector could be contacting the underside of the rails and overloading the axis. Check for 24V on the Z-axis brake. Check the fuse(F5) and voltage to the driver. Check DIP switch settin
Electronics Forum | Thu Oct 21 11:15:00 EDT 2010 | jorge_quijano
Do you know in which axis the problem occurs? usually when "hardware limit error" shows is because one of the axis touches the sensor of the limit, this is to prevent the mechanism hit something, If you machine is used, you can check if there is a mi
Electronics Forum | Thu Aug 13 19:51:47 EDT 2009 | prasadz
Jagadeesh Rajagopalan is the expert in MPM Screen printer Servicing and he suggest to do the calibration of Z axis with PCB thickness (1.3mm)
Electronics Forum | Mon Sep 21 12:15:55 EDT 2009 | swag
Can anyone tell me the correct DIP settings and jumper positions for a MpM AP25HiE Z-axis driver card? Thanks-
Electronics Forum | Wed Jul 21 18:05:44 EDT 2010 | empac
Hello, Does anyone have the following MPM UP3000 Spare part Part number 1001333 Description: MOTOR,M40 Z-AXIS, MODIFIED Thanks. Bob