Electronics Forum | Fri Mar 17 09:03:52 EDT 2017 | daleb
Hello New to forum, I have a mpm ultra print 1500 can not find a lube coupler for the Z axis slide bearings. Does anyone know what it is and where could I find one. A standard grease coupling does not fit. Thanks Dale
Electronics Forum | Sat Mar 28 12:25:48 EDT 2009 | gpaelmo
We have an MPM SPM-AV screen printer and we need to replace the Z-axis timing belt. P/N of timing belt is P2387. Anyone know what the length is does not specify in manual? And instructions on how to remove and replace it? No mention in MPM maintenan
Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Sat Aug 04 08:09:03 EDT 2007 | rich7799
I found the problem... the vx cable trunking was the wrong radius, so when the axis was moving at slower speeds to read pre stop position, the axis was not reading the platen correctly due to extra downward force.. Ive now replaced the trunking and
Electronics Forum | Mon Sep 10 11:50:40 EDT 2007 | chrisgriffin
I assume your vacuum suction is good. Is this an above mounted board stop sensor? -Make sure it is finding the correct fiducial and not a similar object nearby. -Try physically moving the X-axis to check for backlash. There should be no movement.
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Tue Jun 01 17:55:30 EDT 2004 | black5629
I am new with MPM printer,need help.I am trying to teach a new board, after selecting targets,when I exit teach vision ,it errors out "Board Model Not Found". Board orientation is correct. The books talks about Vision Y not squared to axis. Does anyo
Electronics Forum | Fri Feb 15 13:45:18 EST 2013 | cowens
We have a MPM UP2000. We are getting a hardware limit error when we turn the machine on and try to reset. The F14 fuse blows every time we replace it. The downstop is the first axis that it tries to go through but we get this error. Any help would be
Electronics Forum | Sat May 30 07:06:42 EDT 2015 | et1972
Hi I have a MPM3000HI printing machine with a following problem : Unable to run at high speed for z axis ,machine will stop at certain points . Have change ballscrew,nut ballscrew,motor and brake but still the same. Now run at low speed at 1 but t
Electronics Forum | Mon May 03 20:17:40 EDT 2004 | Jacek
Try to check axis drivers - at the begining should be tactile. When you press RESET look on the screen - is there any change (position send from encoders) ?