Electronics Forum | Fri Mar 18 18:51:59 EST 2005 | valuems
Hello Micheal We are looking for the procedure at this time. And there is no tactile sensor on any SPM made by MPM. The SPM's does not have sensor's on the head either. Any way we will send the procedures and the calibration blocks soon. harry
Electronics Forum | Fri Sep 22 11:51:32 EDT 2006 | chris g
Have you tried doing a short diagnostic test? That will check the repeatability and backlash of the axis. Did you use the C-tool when calibrating the camera?
Electronics Forum | Thu Apr 09 10:34:10 EDT 2009 | chrisgriffin
The Z axis is overloading. Could be a connector between the top of the table and the bottom of the rails, or a faulty motor, z-brake, or driver. Good luck!
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again
Electronics Forum | Mon Jun 01 09:29:22 EDT 2015 | tnisbet
Did you change the Z-Axis amplifier? Do you have the old black unit or the new retro(blue box)? Have you checked the rear distribution board for a bad or burnt connection? If you haver any further questions please contact george@goppm.com
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Fri Mar 18 19:17:37 EST 2005 | valuems
Hello PMD Don't feel like that, we live with these MPM's. And we have over 10 years experience. Also never mess with the down stop on any MPM and you will be better off. Most of mpm's machines have a down stop of .0750 and it should never be cha
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Wed Sep 30 06:22:23 EDT 2015 | mervin
MPMENG, Thank you so much for taking the time to help. The machine has Y snuggers and flippers. The Pcb is loading in the center all the time. The driver cards look fine there is no obvious faults on them or partially burned. The machine was not in
