Electronics Forum | Tue Aug 04 10:43:48 EDT 2009 | kpm135
Thanks for the suggestions! It ended up being that a wire on the amplifier card in the lower drawer came loose and was making intermittent contact. Tightened all the wires down and the problem has gone away. Now we have a new problem. We had to repla
Electronics Forum | Wed Oct 20 11:14:55 EDT 2010 | swag
I hope you're fixed by now but my advice is to pull all connectors from drivers and reseat. Also, reseat connectors in I/O area + I think there's some cards that relay power to various axis in this area. Reseat all connectors. From my experience,
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Fri Jul 15 02:26:47 EDT 2005 | fastek
OK...here's another one. The HiE designation began with UP-2000's I believe. And if I'm not mistaken the difference between a HiE and a non HiE was speed improvements as it related to axis movement times. If you could figure out a way to accomplish t
Electronics Forum | Fri Feb 23 08:53:52 EST 2007 | russ
Ours does not have a vacuum option so that may be it, the machine came with an assortment of standoffs and support plates as well. it is not drilled out in a grid but does have the center tapped which I assume is for the vacuum tooling. Ours has a
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Fri May 03 14:52:32 EDT 2019 | rusar
Hi, we bought the old UP2000 (2005 year) and are trying to teach him a new board. But at step 4 (Board stop X-axis) we get an error "Board stop sensor not made". Can anyone help and say what is the cause of the error? BR, Ruslan.
Electronics Forum | Mon Oct 05 13:15:05 EDT 2020 | proceng1
I am trying to replace the anti-backlash nuts for the moveable rail on my ACCUFLEX Printer. I have parts diagrams, but none show the Y-axis width lead screw assembly. I can't figure out how to disassemble the screws to get the nuts out. Does som
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.