Electronics Forum | Wed Aug 02 15:19:29 EDT 2006 | SWAG
Sounds like air pressure is set O.K. The next thing to check is that the platen surface that the x and y axis ride on is perfectly clean. After that, you should knock the camera off the platen and make sure that all of the small air nozzles are blo
Electronics Forum | Thu Dec 04 07:30:50 EST 2003 | ex maintain leader
Hi Grant, I'm ex Fuji Service Engineer, Fuji GP 6xx is the best but for companies in ultra high tech (2 side cleaning+ long life operating, BUT not easy to teach the technicians). Ask Panasert create series is also well durable, but I newer use yust
Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less
Electronics Forum | Tue May 11 10:57:35 EDT 2010 | ehess
Having a problem where i have no drive on any axis. Machine powers up, but won't reset. I have 24VDC from PS6 and PS1, located in the upper drawer. I do not have 12VDC @ PS2 in lower drawer. troubleshooting guide says to check DPR in/out, which I
Electronics Forum | Thu Feb 21 08:20:43 EST 2013 | cowens
Thank you so much. We actually did get the machine up and running yesterday morning. We switched the theta and the transport driver cards and it is working now. We have had the connectors burn on us in the past and replaced them. I am hoping the prob
Electronics Forum | Sun Oct 12 22:08:34 EDT 2014 | cusackmusic
I just got a used AP/C which I guess is also called an AP25? After fixing a few obvious issues, I powered it up, and get a hardware limit error. I have verified that none of the axis are near their limits. Without a manual, I'm not sure where to go
Electronics Forum | Tue Mar 28 19:43:49 EDT 2017 | aemery
Simon, Trying to dust off my 400 knowledge here, I can picture the 500 and 1500 better in my head. I think the 400 also has a Z axis amplifier box in the back of the machine. Remove the rear lower door and pull out the big square vacuum box. If it
Electronics Forum | Mon Feb 14 15:14:54 EST 2000 | dean
Dek 248 / 249 (mfg'95) MPM 2000 Realignment? Are you having to insert print offsets (X.Y, theta)? If yes, your vision cubes are out of alignment. This typically happens if a "crash" occures. A "C" tool can correct this. Or are we talking abou
Electronics Forum | Wed Mar 27 11:30:20 EST 2002 | itempea
Just a question: have you ever tried to transfer programs between 2 identical MPM printers, or between 2 identical CAMALOT Geminis? Well, you'll be surprised to find out that you have to spend 15 to 30 min tweaking them on the second machine. And th
Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799
I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst
