Electronics Forum | Sat Jun 01 10:48:37 EDT 2013 | aemery
Z.Runkle, Gnus is absolutely correct in telling us how to find out the old passwords through DOS. However you asked for the "Calibration" mode password which is a default password and cannot be changed. This password was never given out readily be
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes
Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c
Electronics Forum | Mon Oct 02 10:25:49 EDT 2006 | SWAG
Daxman, Try this: - it might help your histogram. The camera may be operating production reads at or close to the z-axis drive limit but you don't know really. Write a dummy program that will allow you to load a PCB into the centernest at vision h
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Wed Jun 23 10:05:17 EDT 2004 | exmaintenanceleader
Hi Grant, I'm ex Fuji service engineer I install also at Sagem Czecz Republik (Kladnow near Prague) in 2000 they use at new lines MPM- 2XCP643E and 1xUniversal GSM (French owen (I do not remember the exacly tipe) at second hand line they use 2x and