Electronics Forum: mpm z axis brake(p2148) (Page 1 of 4)

mpm up2000 z axis hardware limit

Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze

that doesn't seem to be the issue here

mpm up2000 z axis hardware limit

Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit

I had as I placed the supports at the back - when lifting Z touched the rear rail - check.

mpm up2000 z axis hardware limit

Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze

Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d

mpm up2000 z axis hardware limit

Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1

Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts

mpm up2000 z axis sensor mount location needed

Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze

I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the

mpm up 2000 camera problem

Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin

Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa

MPM UP2000 HiE Z axis software limit

Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135

When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an

MPM UP2000 HiE Z axis software limit

Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag

Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig

MPM UP3000 Question

Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin

I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.

MPM AP-20 z-tower falling/sliding down?

Electronics Forum | Wed Apr 08 18:47:57 EDT 2009 | swag

Could be the z-axis driver card???

  1 2 3 4 Next

mpm z axis brake(p2148) searches for Companies, Equipment, Machines, Suppliers & Information