Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Wed Dec 06 14:06:55 EST 2006 | chrisgriffin
Most MPM's have a DOS operating system only, no windows. Most newer trackball drivers are installed in windows. I haven't had much luck using new trackballs because of this. You can probably find a logitech marble plus on ebay.
Electronics Forum | Mon May 21 22:15:34 EDT 2007 | seb1970
Does anyone know where i can purchase a frame/stencil adapter for the MPM manual stenciler in Ohio? Preferably a air adapter. And also spare parts? Thank you for your help.
Electronics Forum | Wed Dec 06 12:48:54 EST 2006 | seth
usb mouse not detect, and can't install driver. Need instruction on how to install driver since it won't let me copy to C:/ drive.
Electronics Forum | Thu Dec 07 19:04:02 EST 2006 | chrisgriffin
Chunks, your right, I need to get out more. What are you doing Saturday night? Harry is right about the software version compatability with trackballs. What is the version and machine type?
Electronics Forum | Wed Dec 06 15:59:04 EST 2006 | realchunks
Chris, you need to get out more. I haven't seen a DOS only MPM in many years. Most MPMs do have that new fangled Windows on em'. Shoot, even seen one of them fancy flat screens on one (in the rich parts of the neighborhood)! Seth, what type and y
