Electronics Forum | Wed Jun 02 11:19:18 EDT 2004 | black5629
I have a MPM3000, I have tried the multiple models still same problem. When you Teaching Board Stop Y, do you set the cross hair at the leading edge of the board?
Electronics Forum | Thu Apr 20 14:24:54 EDT 2006 | pms
Sr.Tech, Don't know about AP25's, we have a DEK. We have problems with some large board sagging in the middle, causing the board to slip under the board stop, but our DEK has the ability to program the board stop anywhere in the Y direction, allowin
Electronics Forum | Tue Sep 16 14:57:59 EDT 2014 | emeto
Board stopX and Y. Have you tried to run the board on 180 degreese? Or 90?
Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Tue Sep 16 15:54:39 EDT 2014 | gascon5383
I have not tried running it 180 or 90 degrees out. The process involved to change that would be too large for my company to accept it. I see where you can adjust the board stop x and y but is there a way for the z axis? I have found that the board is
Electronics Forum | Wed Jun 02 11:33:00 EDT 2004 | Vinnie
I think you are right. Board stop on Y. Vision square is the stencil fiducials. So if you are using pads.... I am not sure. But why didnt you used board fiducials? none on the board?
Electronics Forum | Mon Apr 24 13:23:37 EDT 2006 | pjc
Use the photo sensor to stop boards instead of the hard-stop. There is also an ultrasonic sensor upgrade. A little more robust than optical. Y Snugger Tooling upgrade is kind of pricey and they like to do that in the plant. But, I've known that upgr
Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t
Electronics Forum | Tue Mar 19 22:58:20 EDT 2013 | vikkaraja
Hello all, it has been a long time since I have visited this forum. I am in desperate need of some help. My cp7 is giving me an err 12200066 (The X- and Y- axis have been stopped due to a (HOLD) input. It stops runing after finish running every boar
