Electronics Forum | Thu Aug 16 09:15:15 EDT 2018 | muzzy
Sarason, thank you very much for your reply. I already have this manual but, unfortunately, it only mentions this elusive "MS Parameters" window but doesn't state how to get there and what is the password. Regards, M.
Electronics Forum | Fri Aug 17 07:50:03 EDT 2018 | muzzy
Hello Stephen, thank you for your reply. This machine uses binary files to store the settings (or at least stores backups as binary files). Also, this "MS Parameters" window contains not only parameters alone but also calibration procedures, so it wo
Electronics Forum | Fri Aug 17 10:18:47 EDT 2018 | charliedci
This might help. See attached:
Electronics Forum | Tue May 07 22:41:32 EDT 2019 | pcbindex1
PCBs applied in vehicles are the fastest growing sub-industry
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Fri Aug 17 07:27:47 EDT 2018 | stephendo
A lot of machines have such parameters stored in an ascii file that can be edited with notepad. But of course doing so could be the fastest way to destroy a machine with a typo.
Electronics Forum | Thu Aug 16 09:10:45 EDT 2018 | sarason
I have a Juki KE750 Instruction Manual if that is of any use sarason
Electronics Forum | Fri Aug 17 10:44:19 EDT 2018 | muzzy
Hello charliem. Thank you so much! Yes, it looks like the information I need. I will try it and report back in a few days. Thank you once again! Regards, M.
Electronics Forum | Thu Aug 16 08:15:04 EDT 2018 | muzzy
Hello! Does anybody know how to access the "MS Parameters" window on older JUKI Pick and place machines? (mainly on 730, 740, 750, 760). Service manual mentions that it is possible to change all of the mechanical parameters from there (like for examp
Electronics Forum | Tue Apr 30 21:13:43 EDT 2019 | marcarmo
Caro amigo Charlien poderia me dizer como proceder o item 11? do arquivo pdf ms parameter window? para mover a cabeça para bloco de calibração? deve ter algum comando ou atalho no teclado para movimentar a cabeça dela e baixar a cabeça até nivel de c
