Electronics Forum | Wed Dec 19 16:05:10 EST 2018 | ldavis
I created a spray fluxer for our wave solder years ago that is still working well although does consume a lot of flux and is also rather messy. It's cheap and easy though so what the heck, right? I just machined a manifold that will hold four BETE
Electronics Forum | Mon Feb 22 22:25:19 EST 2021 | rowan
Hi, We were having flux residue entrapment under the component. So we are evaluating to add steam cleaning with DI water, using precision micro prior to Di wash. Have anyone tried this and what are pros and cons. Your advice appreciated. Thanks
Electronics Forum | Tue Dec 18 04:13:27 EST 2018 | bukas
hello everyone, i'm looking for a spray gun that can withstand flux aggression. I made air controlled prototype for ersa wave machine, but air guns wear out quickly and start to leak. I was thinking about Binks model 95AR or something with stainless
Electronics Forum | Wed Nov 12 08:10:47 EST 2003 | davef
As a minimum, you should observe the recommendations for disposal in your flux supplier's MSDS. For one VOC-Free Flux, the MSDS says something like: Waste Disposal Methods: Scrap material may be disposed of, by a licensed waste disposal company or
Electronics Forum | Mon Jan 14 09:15:44 EST 2019 | davef
Suppliers list the contents of their products in a MSDS. Libraries of these sheets are listed online. Look up the product you're using there. A safety data sheet, material safety data sheet, or product safety data sheet is a document that lists info
Electronics Forum | Thu Apr 09 12:13:22 EDT 1998 | raymond
What is the pro & con of using flux dispensing vs flux dipping method for flip chip assembly ?
Electronics Forum | Wed Nov 12 10:45:12 EST 2003 | johnthor
Absolutely, read the manufacturers MSDS. You do have it, don't you? We use Kester 971 and it reads Waste Disposal Methods: According to local regulations. Considered biodegradable. We did take the precaution of informing the local authorities and
Electronics Forum | Fri Apr 22 10:50:51 EDT 2011 | blnorman
Quick question, how are you measuring the effectiveness of the cleaning process to remove the flux?
Electronics Forum | Mon Aug 19 11:36:27 EDT 2019 | bulur
How does no-clean flux residues on a PCB assembly impact the ROSE testing? Does no-clean flux residues on the PCBA dissolve in solution of ROSE tester and increase ionic contaminants level in terms of NaCl per surface area? Is ROSE tester solution (a
Electronics Forum | Wed Jan 18 16:03:08 EST 2006 | Klevesqu@vtc.edu
Hello, I am wondering where I can purchase and read up on the specs for the proper solder flux pastes for Luxeon emitters. I notice in there aplication briefs they mention 380SR-flux gel and a few others but I no clue if that is a model number or wha
