Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Fri Jul 19 12:58:46 EDT 2013 | markhoch
The wonders of Google... Hope this helps. http://www.winsmt.com/down/001.pdf
Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Wed Oct 03 15:43:24 EDT 2018 | gpascolla
We have a Juki FM-740 that we just received that will boot up fine when it wants to origin the servo drive does not engage. Nothing lights up but I do have power to all 3 units (X, YL and YR).
Electronics Forum | Wed Jul 09 12:00:25 EDT 2014 | bobpan
You have a rather old machine that you are running....now realizing this you need to check some things. 1. Clean the scales in the x and y direction. On some of the encoders there is an led to see if its reading correctly....Usually it turns green b
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Thu Oct 13 14:09:44 EDT 2005 | rcanten
If there is no option to send the proper data to the MTU it sounds like your line editor is configured incorrectly. You will still be able to send programs and the such but like you said you would never notice it until you had to send the proper back
