Electronics Forum | Wed Oct 12 22:22:31 EDT 2005 | zl3vlf
Hi all! Well installing the servo card has fixed the status LED issue....however there is a new problem :( When a production program is executed at the IP3 (pressing AUTO or START) the machine says 'communicating with the VP' (which is normal). Wh
Electronics Forum | Wed Mar 11 13:18:32 EDT 2009 | smellew
Even if you disable the MTU(see address 1005 to link out E-stop & address 1219 for the safety fence rear) the servo still needs to be replaced. SA6 is the faulty one, i'm sure there are many dealers who could supply you one. if you need further conf
Electronics Forum | Fri Sep 16 15:17:08 EDT 2005 | vikkaraja
Most likely servo amp is bad.
Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Fri Sep 16 08:36:45 EDT 2005 | ajay
check some relay might be bad on MTU. we faced similar problem in IP3.
Electronics Forum | Thu Sep 15 10:25:13 EDT 2005 | lyrtech
Hi, this morning we got a "servo alarm MTU" on our FUJI IP-2. On a servopack, I see an " Over Current" error. what does it mean? I don't know hoe to check that. Can anyone help me? Thanks a lot.
Electronics Forum | Thu Sep 15 16:02:20 EDT 2005 | jdengler
Over Current means the motor is drawling too much current. Check for a jam on that axis, bad wire, bad motor, bad servo amp (yes the amp can go bad and make it appear that the motor is drawling too much current). Jerry
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Tue Feb 11 15:31:10 EST 2020 | sumote
We have not used out tray handler in several years, and when I had a need arise the thing now throws a Servo Error "MTU1 ALARM [11081010]. There are 4 servo packs in the cabinet. When I try to initialize/zero out the machine the 2nd and 4th servo pa
