Electronics Forum | Thu Sep 15 18:02:52 EDT 2005 | GAK
If the end sensor is bad it will cause the axis to past it and travel against the end stop and cause an over current also. So it kind of depends on what the machine is trying to do.
Electronics Forum | Tue Mar 10 15:24:28 EDT 2009 | smellew
Rodrigo, I'm not available tonight, if you have a new servo amp change it pay special attention to the jumper settings there are 2 types of amp you can fit see drawings for info. the original info you posted, re the MTU i believe is not related but
Electronics Forum | Mon May 04 22:42:46 EDT 1998 | Phillipf Hunter
Okay, Fuji MTU4 experts...I need a precise way to determin the X-origin and Y-origin of the tray plates. The center of the S-nozzle referenced to the plate corner is very difficult to EXACTLY measure. I need accuracy to pick small QFP28's - otherwi
Electronics Forum | Thu Sep 16 18:43:57 EDT 2010 | slwolbert
Hello Daxman, Thanks for the input. Yes, the CP2 is closely related to the CP4 and does have the analog servo amps as you deduced. I did a wiggle test on the connectors and found that the x-y-r servo amp alarmed right away and blinked the x axis a
Electronics Forum | Thu May 21 20:25:26 EDT 2009 | voytek
I had to replace two Y-axis servo amplifiers on our GSM1 machine. I'm sitting on two faulty servos that I would like to have repaired. Let me know if you now place which specializes in repair of Servo Amplifiers Mod. No. 800-444 by Copley Controls.
Electronics Forum | Mon Mar 09 17:42:56 EDT 2009 | smellew
ok Please power on the machine & confirmed that M1CP 2 is ok this is the breaker for the 35V & check M1cp1 now look at the drawings at address 1011 & check the axis ready relays Z1 11CS3x 151-GB Closed is ok if open see address 5402 Z1 servo amp is f
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
Electronics Forum | Wed Oct 17 14:26:30 EDT 2012 | dman97
With that said, do you happen to have the calibration procedure for the MTU? I already have the X0 Y0 jig. Just need to know where exactly I am supposed to calibrate with regards to the actual trays.
Electronics Forum | Mon Nov 09 08:50:08 EST 1998 | Larry Johnson
Here is a good one for ya. Our IP3's MTU will not pick QFP240's out of cavities, 10, 12, 13, 15. This is a 3X8 tray. The listed cavities are also the closed cavities that are used for tray eject. There is plenty of vaccum, the nozzle comes down f
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power