Electronics Forum | Sat Sep 11 08:19:54 EDT 2010 | slwolbert
Greetings: I am having 'Check Servo' issues with an FCP 2 4000. It will zero set but given a few minutes afterwards, the check servo alarm sounds. At times the X/Y table will 'coast' back to beginning position, like the power has been cut to the
Electronics Forum | Tue Nov 10 12:06:59 EST 1998 | Steve Herring
Larry, We place QFP240's all the time with our 2 IP-3's. If you provide your e-mail or fax number, I can send you the PD that we use for our QFP's. Steve | Here is a good one for ya. Our IP3's MTU will not pick QFP240's out of cavities, 10, 12,
Electronics Forum | Thu Nov 12 18:08:38 EST 1998 | Steve Abrahamson
Larry, We once had a problem in which the IPIII would pick on one area of the tray and not on another. It turned out to be the vacuum hose. There was a small crack/cut in the hose, and when the robot (and attached hose) was in a particular positio
Electronics Forum | Thu Nov 12 18:39:10 EST 1998 | Phillipf fHunter
| Here is a good one for ya. Our IP3's MTU will not pick QFP240's out of cavities, 10, 12, 13, 15. This is a 3X8 tray. The listed cavities are also the closed cavities that are used for tray eject. There is plenty of vaccum, the nozzle comes down
Electronics Forum | Fri Oct 27 03:02:54 EDT 2017 | praveenmuthusamy
Dear All, what might be the reasons for servo alarm on W axis in YXI(X RAY INSPECTION MACHINE)?? MAKER: YAMAHA TYPE: KLC-0000 NOTE:MACHINE CANNOT BE RESET UNLESS POWER SHUTDOWN. MACHINE RETURNS TO NORMAL STATE ONCE POWER SHUTDOWN AND RESATARTED! R
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Tue Oct 11 19:17:29 EDT 2005 | Dave
Hi Stephen! The nozzle change happens at a much slower speed to what it runs at during pick and place. They are a great machine...when everything works on them ;-) I tried sending through the proper data again and rebooted the machine. A interest
Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh
Electronics Forum | Thu Jul 06 19:41:31 EDT 2000 | Hermie
We recently installed a new Servo-Amp which controls the X-Y table on our CP6 machine. Eversince, we are experiencing a Cycle alarm X-reach on the machine. We tried to greased the table a little bit more but the only thing that seems to work is to sl
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
