Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Wed Oct 29 13:00:27 EDT 2014 | Todd Grover
We have a Cencorp TR1000 Router that has been recently having problems. Frequently it will freeze up. This usually happens after running it for awhile. Sometimes the machine and computer both freeze up. When this occurs we have to completely shu
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Fri Jun 19 15:03:15 EDT 2020 | jmelson
OK, I am really happy with the robustness of my CSM84. I wonder how hard it would be to hack up one of these 3-phase machines to run off single-phase power? Mostly, it just feeds a big DC supply for the X-Y servos. 2 heads with ANE should be just FI
Electronics Forum | Sat Feb 12 09:38:39 EST 2005 | primus
I think you may be assuming that our operators aren't already doing that. We need to be able to bypass the interlocks... how do you think our operators make line adjustments? Step the machine, drop the tooling, and eyeball it. That's it. The operator
Electronics Forum | Fri Jun 02 17:19:56 EDT 2000 | Big K
I am currently experiencing several problems with QFP's on one of our IP3's. The first problem is with QFP240 devices. We are experiencing a high reject rate with these parts when using vision type 100. What appears to happen is that the vision syste
Electronics Forum | Thu Sep 16 21:22:39 EDT 2004 | Darby
Cesar, I am not familiar with these machines but I have found that servo controller problems do not usually cause mis-placement. They tend to just stop the machine with *axis system erors. As I understand it, after you have done a return to origin,
Electronics Forum | Thu May 12 04:37:30 EDT 2005 | Rob
1) Only if it's a real enhancement, and not to fix a fault in your design. 2) No, it just has to be instinctive & accurate. 3) Barcode is fine by me, but others swear by data matrix 4) Better than 1 in 10,000 - which could be once every 5 boards.
Electronics Forum | Fri Mar 11 09:42:07 EST 2016 | oxygensmd
I am trying to decide how to best dispose of our > old running Siemens equipment. I would like to > get something for them but I am not sure who > needs these older machines I have about 8 > available; any ideas guys? > I am trying to decide ho
Electronics Forum | Tue Mar 06 04:58:58 EST 2018 | reckless
My wish would be to put 2-3 smaller 4 nozzle/7000cph desktop units and not in line saving me changeover time. Mostly because of the small real estate footprint. I can put one next to my office running 110V/350W - its small enough to fit on my desk
