Electronics Forum | Fri Jul 27 11:22:26 EDT 2001 | cjrjmj
I would like to hear about equipment (all existing) that would do DIP insertion. We have UIC Multimods presently, but as you may or may not know spares and support are becoming an issue. All input is appreciated!
Electronics Forum | Fri Sep 03 08:25:30 EDT 2010 | remullis
I removed the muffler yesterday and still had the latch releasing issue, the latch was tight, however the table had some play in it. I adjusted the play out of the table, setup table zero and it fixed the problem. Same symptom as if the latch were lo
Electronics Forum | Fri Jul 27 12:16:43 EDT 2001 | davef
Look here http://www.cassembly.com/bg/search?company_name=&catid=1056⊂mit=Search UIC and Amistar make good DIP insertion machines. Some of the companies listed in the above thread are equipment resellers that may be good sources of refurbished equi
Electronics Forum | Thu Sep 02 19:22:08 EDT 2010 | fulldrawmike
seen it on a uni-mod many times. there is a muffler near that assy that if dirty will cause the air dump to back up and not exit out the muffler. if yours has one, remove it and see if it stops the table latch. it will be loud but it will let you k
Electronics Forum | Thu Sep 02 13:19:52 EDT 2010 | remullis
I am having issues with the air dump on this machine. When you palm down or break interlocks the air dumps as it should however I'm getting a short burst of air back through the system. The problem with this is it's just enough to trigger the table l
Electronics Forum | Mon Jan 11 07:47:21 EST 1999 | Wendy Casker
| Does anyone know 2-pin DIP components? Who uses them, why are they in the DIP form and not simple axial components? Are they usually placed by hand or by modified DIP placement machines? | Thanks for any answers, | | Erhard | Good Morning, 2 pin
Electronics Forum | Wed Sep 11 20:36:04 EDT 2013 | action_101
UIC still manufacturers new thru-hole machines. Both axial and radial insertion models are available. They stopped making the multi-mod dip inserters in '91 or '92. And parts are easily acquired for any older models, there were a ton of machines out
| 1 |
.png)
