Electronics Forum | Thu Sep 02 15:01:52 EDT 2010 | James Neal
Manufacturing-wise, is there a problem with doing a single panel with both four layer and two layers designs on it? I do prototype runs with multiple designs on the same panel, and I'd like to start including four layer. It seems to me that I can g
Electronics Forum | Tue Sep 07 11:17:43 EDT 2010 | ysutariya
The only issue is that now you are paying for a 4 layer board and only getting a 2 layer board. In the long run, it will definitely cost you if this is a higher running product. Other than that you shouldn't have any issues.
Electronics Forum | Tue Jan 17 14:59:03 EST 2023 | symakhan
Hello Again A few days ago, I posted about Solar panels installation in my construction project. I got amazing response from everyone. I am grateful for all the advice and suggestions. I am also sharing all the details here in hope they will be help
Electronics Forum | Thu Aug 21 06:30:32 EDT 2014 | karolis
We are running mainly aluminum boards and lots of them are not square shaped. You can panelize any shape board, you need just add little routing to your panel design. I attached one picture with panelization example (routing and V-cut mixed).
Electronics Forum | Wed Aug 20 14:16:57 EDT 2014 | jax
I have a few questions: Why are you unable to panelize an aluminum board? We run aluminum boards all the time utilizing both V-Score and Routed designs. Panelization aside, what are the issues that you run into at printing? Are you trying to print
Electronics Forum | Thu Feb 15 20:27:11 EST 2007 | vshan
Hi Chris Good Day!!!! well we are running flex panel(150x270) with one connector(3 pin legs both sides) insert. Each panel consists of 28 parts and its used for disk drive industries. We are having a pallet to support with the top cover design such
Electronics Forum | Thu Feb 15 21:59:09 EST 2007 | vshan
Hi Jim Good Day yes we are using a pallet bottom support as well as top cover. The top cover are design such a way that the solder paste area is open. the type of solder is lead free type(Avantec-ecorel free) in one panel consists of 28 parts and e
Electronics Forum | Wed Nov 21 12:29:52 EST 2001 | mparker
Now that we know where you've been and what you wish to accomplish next, I can still give you some suggestions. 1. Get IPC-7912. Use it to evaluate your CM's. Especially if you have multiple contractors supplying like products. You will quickly see
Electronics Forum | Sat Jun 30 11:28:24 EDT 2001 | davef
Consider using a roll solder with a flux that well matches the residues you can accept to be remaining on the board when you get finished processing. Many people use a no-clean flux cored roll solder for such operations, because they don't want to c
Electronics Forum | Tue Feb 20 16:51:22 EST 2001 | davef
You should evaluate products from Datapaq, Electronic Controls Design, and Kic Thermal Profiling. Each sells very good reflow profiling equipment. Beyond the straight forward issues surrounding the question of "Does this thing produce a good profi
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
