Electronics Forum | Wed Mar 04 14:06:57 EST 2009 | chrisgriffin
Has anyone ever seen a designator "TH1"?? I am replaceing a component on a Fuji CP-6 MX100 PLC. It looks like a gray cap, but the designator is TH and it has a resistor symbol under the part. Markings on the part are: S 22007 A J
Electronics Forum | Wed May 16 11:33:21 EDT 2018 | gfe
Hi everyone, anyone knows what is the option in advanced 2 that says (USE 100W HEAD) on Pick & Place Mirae MX200L and MX200LP.
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Wed Mar 18 11:39:06 EDT 2009 | chrisgriffin
Greg, You guys are right, it was a thermistor. I believe the machine was powered up with the wrong voltage. Here is what gets damaged if the transformer is tapped for 230 and you apply 480: 1. Both CPU modules on the MX100 PLC's blown. 2. Both col
Electronics Forum | Fri Feb 09 16:29:22 EST 2007 | dave
Hi All, Thanks for all the replies. I am placing a 672 Pin BGA. Its the only BGA on the board (Board size 220mmx100mx1.6mm) We build these in batches of 400. So we have built approx 1200 since transition to Leadfree. Latest batch had 7 fails -
Electronics Forum | Thu Mar 11 12:11:02 EST 2004 | russ
Jon, one other option. Metcal makes tips for the MX stations that are for removing All sorts of Ic components. They are custom sized for each QFP size. If you have the MX stations this is a great way to go. These tips only heat the leads and par
Electronics Forum | Fri Mar 30 06:59:00 EDT 2018 | bobpan
In Production Monitor....there is Utility and Axis speed. Make sure the z-axis are set to 100%. I would also check to make sure in your component information that you dont have your parts slowed down or have long place and/or pick delays. good luck
Electronics Forum | Mon Oct 18 08:02:35 EDT 2010 | marusha
Hello, colleagues! Please help make a choice! (MY500 + MYDATA MY100 + Heller Mk1707) or (Dec Horizon03 + Samsung 421 + Essemtec RO400FC-C) or very cheap Korean equipment (Sj InnoTech; HP-520 + Mirrae Mx350P + TSM; A70-i71). The volume of required c
1 |