Electronics Forum | Mon Jun 16 10:52:02 EDT 2014 | robstarrs
bobpan quick background. I am very new to the Quad machines, I used to "run" one, but I never learned the inner workings of a machine. I just purchased 2 used quad 4cs, I had a training session over the weekend with a very knowledgeable guy and l
Electronics Forum | Thu Oct 16 04:46:46 EDT 2014 | haiae
I'm looking for a new or used servo motor for my Yamaha YG100R PnP machine with original model: Q2GA04006VXS2C (Sanyo denki ) If anyone can offer it please contact me ASAP. Thanks & best regards,
Electronics Forum | Fri Oct 28 04:14:18 EDT 2011 | kenmar
I have a loud humming noise coming from my MY12 X-Motor ( Like when a motor is not locked in and it hunts). This noise is not all the time but only sometimes especially with fine placement!! What can it be? I do not want to change the Motor to find o
Electronics Forum | Sun Jun 12 01:38:47 EDT 2022 | mikevb
I'm having a problem with my Mydata My9 pick and place. Basically whenever I try to run the placement calibration program or try to have the machine find fiducials, or basically anything with precision, the machine displays a X MOT motor timeout erro
Electronics Forum | Sat Oct 29 12:53:34 EDT 2011 | dontfeedphils
We had the same motor problem with our My12, whenever we would get the sound we would go through and slow down X accel speed in any packages and the placement accuracy as well. After doing this for quite a while we finally tried updating the motor c
Electronics Forum | Wed Jan 29 13:01:04 EST 2014 | tech1
Back when the Linear Y wagons first came out Mydata had problem with the original Y amplifier and were swapping out the complete box for customers who had problems. There was also a problem with the encoder that resulted in the same type of errors yo
Electronics Forum | Sun Jun 12 01:44:59 EDT 2022 | mikevb
I forgot to mention that I've measured and adjusted the cog play on the x axis and so it is within range, if that applies.
Electronics Forum | Wed Jan 29 18:41:22 EST 2014 | alphatronique
Hi did you look for mechanical issue like friction somewhere ? when init i use very low force buy much more while running that may explain wly machine work in production fur fail only on init i face that whit flex cable that make just little fr
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
