Electronics Forum | Wed Aug 22 14:57:47 EDT 2001 | mparker
Lookit here, Mugwump, The SMT community at large is composed of a vast array of expeiences, some barely with SMT 101 behind them to others who have probably already forgotten more than you'll ever learn. Without direct, personal contact of any
Electronics Forum | Wed Dec 07 09:35:59 EST 2011 | upguy
We have a MyData TP9-UFP that we would like to network with a PC as a network. The documentation that we have is, at best, minimal. To export files, our choices with TPSys 1.5.18 are DOS-disk, UNIX, Kermit and FTP. The files are too big for a flop
Electronics Forum | Fri Apr 01 01:26:17 EST 2005 | Marv
A couple of things.. 1) The problem is more than likely on the magazine board itself (TC2), most likely the pal chip that stores the serial number and feeder information (you could swap this with a working magazine to verify) 2) The magazine connecto
Electronics Forum | Wed Nov 03 12:08:59 EDT 2010 | hegemon
I had an opportunity two years ago to evaluate three benchtop AOI systems. Omron, Yestech, and Mirtec. I was fortunate to be able to have all three machines side by side for my evaluation period, which lasted near a full month. At the time I was
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Tue Feb 03 13:39:08 EST 2009 | grics
Good morning Jamie. I work at a CM and can offer some input on process flexability. I do not have any data on how reliable the coating is but I can say that they are both very difficult to control. Will you be selective coating or full coating? Ho
Electronics Forum | Tue Nov 15 14:01:00 EST 2011 | olddog
Well, everything WAS going OK until I started setting up for a board job (40 boards with about 450 components each - many image repeats). We setup 37 feeders with their parts and started defining the pickups and placements. Part #1 is an SOD123 zener
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
| 1 |
winsouce.jpg)