Electronics Forum | Tue Jan 16 07:51:23 EST 2007 | leemeyer
I have found a screen in the software that appears to be some setup data for the conveyor. I cannot find any information in the manual refering to this screen. If you open "SCREENS" then "DEBUG DATA" then "CONVEYOR" there are some setup parameters. D
Electronics Forum | Tue Jan 31 18:50:01 EST 2023 | markhoch
You might want to look into the Vorne XL Productivity Appliance. You connect it to your line by connecting it to a sensor that will trigger an input. (I used the exit sensor on the pre-reflow conveyor). It's probably the most cost effective productiv
Electronics Forum | Thu Apr 19 07:42:53 EDT 2012 | leemeyer
I just purchased a used Universal Instruments Boardflo conveyor model 5363. It looked like it would be perfect to connect 2 of my Quad 4c machines in line. it came with a SMPI to Smema converter box. I connected the box S1PL and S2PL to what I beleiv
Electronics Forum | Wed Nov 02 12:49:59 EST 2005 | Olas
Thank you for the advice, Mika. My question however was not generated by a practical problem, but rather from the fact that we have to design an equipment which must interface with other conveyors. By now we�ll ignore those two points. Regards, Ola
Electronics Forum | Sat Oct 22 03:53:48 EDT 2005 | olas
Thank you guys, I wasn't really pulling my hair out, but I feel better after reading your point of view! Have a good day, Olas
Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Tue Jan 24 12:39:24 EST 2023 | linux
Hello MagyarT, Software that Combines data from Kohyoung AOI,SPI and panasonic assembly machines YJLINK conveyors to track back quality root causes of defects -See real-time OEE on your panasonic lines at each location -Drill-down on SMT bottlenecks
Electronics Forum | Thu Mar 23 23:21:10 EST 2006 | AR
100 cm/min) the motor runs without complaint. Too bad we run the conveyor as slowly as 10 cm/min... I'll try replacing the control board next when I get my hands on one.
Electronics Forum | Mon Oct 06 15:03:42 EDT 2003 | ssnow
I would like to hear from anyone who has ever successfully spliced conveyor belts, or who know's where I can get my hands on a splicing iron. I have belts that are broken or just need lenght modifications. please let me know if anyone does this and w
Electronics Forum | Sun Nov 24 01:49:19 EST 2024 | poly
I originally assumed the rail calibration required a cal kit but you can use any board. So I can calibrate when I have it set to right to left and everything works correctly. If I change it to left to right by running the settings program, then atte
.gif)
winsouce.jpg)