Electronics Forum | Thu May 26 15:28:41 EDT 2005 | jh0n!
It looks like there's another one or two threads somewhat similar, but allow me to pose another. We've only about two years experience in SMD production, and we're just starting to really ramp-up. As we stand right now, I'm not recieving informatio
Electronics Forum | Wed Jun 24 16:10:09 EDT 2020 | landrysmt
Hello, Finaly, What was the problem on your Hydra head? Maybe my message comes too late, but my answer might help ... It could be linked to a problem with the Hydra Z motor / encoder. In certain circumstances, the Hydra Z axis is not in the correct
Electronics Forum | Mon Oct 12 01:20:42 EDT 2020 | azdback
LandrySMT, after monitoring the errors and considering what we replaced, I also decided to replace the Z hydra motor and encoder. That fixed our problem. I looked at your message and I agreed that the next step was to replace this part. We ran hi
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
Electronics Forum | Wed Feb 01 18:10:03 EST 2006 | HN
I'm using Fuji Flexa with ip3 and cp65, can I get the parts data file? my mail is hai.hnguyen@sanmina-sci.com. thanks
Electronics Forum | Fri Jul 08 10:45:17 EDT 2005 | dougs
Jack, Your telling me to do what i wanted to do anyway, My first question on the thread was where do i get this type of software.
Electronics Forum | Wed Jul 06 09:51:23 EDT 2005 | Jack
Doug, It always seems easier to fix one or two problems by eye at the time. The real problem comes when the customer wants the same board run again later. You're okay if you saved the corrected placement routine, but if you end up moving the job t
Electronics Forum | Thu May 26 19:29:35 EDT 2005 | jh0n!
Yeah - I can handle most scripting/programming - but I'm completely unfamiliar with this side of these machines. For example, when looking at the Aegis software, they're tracking real-time defects, etc....That's what I'm curious about there - how to
Electronics Forum | Sun Aug 14 22:58:17 EDT 2005 | crishan
Hi All, I would like help in establishing what is a feasible PPM reject rate from a typical SMD line. As a reference an SMD line consists of, solder paste printer, chip component placement, pick and place IC components and reflow. What is a bench
winsouce.jpg)
